Thermostat and temperature limiter

With manual reset

Thermostat and temperature limiter with manual reset

Tubular elements with Ø 8.5 mm can be supplied with fitted thermostat and temperature limiter with manual reset. These are fitted at the end of the electrical element. This element design with fitted BTS and BTC is approved by NEMKO, VDE and UL and is especially suitable for heating fluids.

 

To decide which cut-off temperature the temperature limiter should have, measurements must be taken under actual operating conditions. The cut-off temperature must be at least 25–30 °C higher than the maximum temperature of the temperature limiter during normal operation.

 

Technical data


Thermostat

Temperature limiter

Type designation

BTS 085 060 (10) 130

BTC 085 060 (10) 130

Cut-off temp.

60 (10) 130°C

60 (10) 130°C

Tolerance

plus minus 5°K

plus minus 10°K

Operation

plus minus 1°K

plus minus 1°K

Max. voltage

250 V

250 V

Max. current

10 A

12 A

Contact resistance

< 20m Ω

< 20m Ω

Ambient temperature

T 180°C

T 180°C

Certificate

Nemko-certificate nr. 945010701

Nemko-certificate nr. 982103601

Compliant with

EN 60730-2-9:1995

EN 60730-2-9:1995

Connection

Normal flat pin or cables spot welded to the connection bolt

 

Advantages

  • Does not take up space outside the tubular element
  • Does not require extra cable connection
  • Is ready fitted in the element
  • Secure cut-off near the heat source
  • Functions with low cost

 

Examples of use

  • Dishwashers
  • Washing machines
  • Photographic developers
  • Hot-water tanks
  • Coffee makers
  • Air heating with forced through-flow

Related products

NORSKE BACKER AS · JOSTEIN SVENHEIMS VEG 8-10 · NO-2212 KONGSVINGER · TEL. +4762828828 · [email protected]

2017 Backer AS | All rights reserved