Dyseelementer i spesialutførelse

For spesielt korrosive miljøer

Nozzle elements, special design

Special design

Sheath in stainless steel for extremly corrosive environments such as for injection molding of parts in PVC, which also allows higher temperatures and surface loads, 7W/cm2. Thermal sensor type J for temperature regulation. Alternative connections see above.


Assesmbly instruction

Socket head cap wrench 4 mm is used.

It is very important that the nozzle element is tightly assembled to avoid any internal voids between elements and injection molders, for example. After the first heating the nozzle element must be after-stretched. Bending of the connection cable close to the element to be avoided. Remaining plastic material at element surface can be removed by heating to melting point. Avoid impact to the element and take good care when removing plastic.

NORSKE BACKER AS · JOSTEIN SVENHEIMS VEG 8-10 · NO-2212 KONGSVINGER · TEL. +4762828828 · [email protected]

2017 Backer AS | All rights reserved