Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Read online
Cartridge heaters, or high power elements, can supply very high power to a specific area and are mainly used to heat tools. Thanks to the design, the heat is quickly distributed over the entire surface of the element and the elements comply with the high demands for impact resistance to impact and vibration security.
Material | Stainless steel AISI 321/EN 1.4541 |
Dimension | Ø 6.5 , 8, 10, 12.5, 16, 20 mm Inactive section approximately 10 mm at the connection end and approximately 5 mm at the other end. |
Connection | 250 mm fiberglass-reinforced nickel wire Helical protective hose, zincified steel strip Wave hose (gas- and liquid tight) Reinforced, hose, zincified Right angle casing |
Others | Broached holes are required. Tolerance H7 (Swedish standard). If a surface load greater that 20W/cm2 is required, individual adjustment is necessary. |
PRODUCTS
COMPANY
LEARN MORE
BACKER AB · FABRIKSGATAN 11 · SE-282 71 SÖSDALA · TEL: +46 (0)451-66100 · [email protected] · Corp. reg: 5560530569
Copyright © 2017 Backer AB